How to make your own customized growing netting.
What is Growing Netting?Growing netting is an equipment which gardeners make use of in supporting their plants and helping the plants to stand upright. It comprises of a five by five inches square and can be bought in various sizes. This net at the end stretches and is tied to some form of a frame in order to allow the vining plants to breed in an upward or vertical way rather than spreading everywhere. Making this net is not as hard as one may think, so let’s show you what you need if you decide to make yours instead of buying.imagen 1Components for a growing netting It is important to note that the mentioned components are for a single construction.
- 1 conduit coupling
- 2 to 4 long 3/8″ diameter rebar
- pack of zipping ties (optional)
- 2 to 10 pieces of ½″ electrical conduit
- 1 pack trellis netting
- scissors or cutters
- tape measure
- conduit bender
- pipe cutter or metal saw
- The rebar should be driven into the ground measuring two feet. The position for this is where you will put the trellis. Perhaps you are using a bed that is raised, you can find out the best place to put the rebar.
- The next step is measuring and marking the height of the trellis that you want on the conduit.
- Twist the conduit within an angle of 90 degrees. If the bending of the conduit is new, then you have to assign notch for the beginning of the bend.
- Both pieces of the conduit should be placed on the rebar and straighten the pieces for joining. This will be dependent on the raised bed size and might require some cutting down. At times, it is much easier and technical if you measure and cut, but there is no much time to do that.
- Once you are done with the cutting of the conduit to shape, join it using a coupling. For a perfect fitting, you need to adjust the bends or twists.
- Lay the frame on the ground after removing it from the rebar. At this point, you open the trellis and unwrap it. This will have the appearance of a jumbled mess of spaghetti.
- There is a nylon string, which is about 2 inches in length for the edge of the growing net. Begin from the twisted corner, work down, and crossway as you tie the corner to the frame.
- You will need to cut off the trellis netting once you are at the end of the frame
- At this point, you can keep the new frame on top the rebar while you wait for the vining plants to move towards that direction. These vining plants need to be trained as they grow.
HORTOMALLAS manufactures and markets crop support nettings (trellising and tutoring as alternatives to the raffia twine labor intensive traditional system) that increase crop quality. Our Mission is to: INCREASE VEGETABLE CROP YIELD AND PROFITABILITY TO ALL THOSE VEGETABLES THAT NEED TUTORING AND SUPPORT USING NETTING INSTEAD OF RAFFIA. Since 1994 we help professional growers and farmers improve their cucumber, tomatoes, melon, zucchini, bean, chile, peppers crops where trellises and supports are needed. HORTOMALLAS is the ideal system for cucurbitacea and solonacea to improve their phytosanitary conditions, while increasing the solar exposure and the brix degrees. Besides the obvious labor costs savings, the use of HORTOMALLAS increases the life span of the plant, allowing longer periods of harvests and of a greater quality. Call us, our crop specialists will help you with specialized attention in the Americas and the Iberian Peninsula!