USA, FL +1 (904) 250-0943
  • Brazil Brazil: +55 (11) 3181-7860
  • Spain España: +34 (95) 093-0069
  • Guatemala Guatemala: (502) 2268 1204
  • Mexico Mexico: +52 (33) 1031-2220
  • Mexico Mexico: 01 800 PA MALLA
  • United States United States: +1 (904) 250-0943
  • United States United States: 1 877 CROP NET


Growing tomato plants in a vegetable garden shouldn’t be a big challenge. Most tomato plants are climbers and often need a helping hand to reach their full potential. Depending on the size of the garden or farm, using horticulture string is very ideal, especially where space maximization is necessary. This is because, such strings enable plants climb, thereby conserving space. Stringing implies allowing your tomato plants climb up a single string, a method which results in very tidy looking rows of tomato plants. Allowing your tomatoes climb is a good idea (if they are climbing tomatoes) for a good number of reasons. The use of horticulture string is ideal because, the best way to protect your tomato plants is to ensure they have light and air at every level of their growth, so stringing them up is smart. Light helps keep them safe from fungal diseases, which can stunt their growth or even kill them off. Tomato plants also require heat to flourish and that cannot happen when they only end up forming a pile on the ground, especially if they are climbers. Explaining the ways to train tomato plants using horticulture strings Horticulture strings come in handy for tomato pruning. When it comes to tomato pruning, one of the favored methods is the French pruning method. This method is very useful when the farmer has a limited amount of space for the tomato plants. It follows these steps:
  • To start the process, in the case of outdoor gardens, prepare the ground with a lot of compost. Plant out a row of tomato plants about 45 cm apart. Fix a few stakes to tie the tomato plant up to, as it grows.
  • Run a string between two 7-inch-high stakes and tie it so it hangs down towards your tomato plants. Here, a single horticulture string dropping down to every tomato plant is required.
  • Prune your tomato to one leader and remove all the suckers. Then wind the string around the base of the plant multiple times.
  • Afterward, twirl the tomato plant around the string until it is taut. When the tomato plant begins to grow, twist the string around the stem of the plant so it grows upwards. The first time the horticulture string is wrapped, it should be focused on the base of. It should be wrapped multiple times and kept tight and safe. One can equally use a floral tape, a plastic clamp or a knot to secure the string at the base of the tomato plant.
  • Continue to remove suckers and twist once a week until the end of summer. Get rid of lower leaves as the plant matures. You can decide not to remove all the side shoots and let it spread out so it does not become too tall. However, you should also consider the size of your garden while making this decision.
Apart from tomato plants, Horticulture strings, also play a role in the growth and support of other climbing horticultural plants.

Leave a comment